2011 Lincoln MKS Base, FWDFACTORY OEM SERVICE PROCEDURE

Common Specifications & Procedures

MKS COMMON SPECIFICATIONS & PROCEDURES

System Specification/Procedure
Air Conditioning
Service GENERAL SPECIFICATIONS
Torque TORQUE SPECIFICATIONS
Axle Nut/Hub Nut
Front Hub Nut 258 Ft. Lbs. (350 N.m)
Rear Hub Nut 98 Ft. Lbs. (133 N.m)
Battery BATTERY
Brakes
Bleeding Sequence RR, LR, RF, LF
BRAKE SYSTEM BLEEDING
Disc Brakes w/Torque
Front SPECIFICATIONS
Rear SPECIFICATIONS
Charging
Generator w/Torque SPECIFICATIONS
Drive Belts
Adjustment REMOVAL AND INSTALLATION
Belt Routing REMOVAL AND INSTALLATION
Engine Cooling
General Service Specifications SPECIFICATIONS
Radiator Cap Pressure 14 psi (96 kPa)
Thermostat R & I THERMOSTAT
Water Pump R & I COOLANT PUMP
Engine Mechanical
3.5L GTDI
Compression COMPRESSION TEST
Oil Pressure (minimum at 1, 500 RPM, engine at normal operating temperature) 30 psi (207 kPa)
Overhaul SPECIFICATIONS
Torque SPECIFICATIONS
3.7L (4V)
Compression COMPRESSION TEST
Oil Pressure (minimum at 1, 500 RPM, engine at normal operating temperature) 30 psi (207 kPa)
Overhaul GENERAL SPECIFICATIONS
Torque TORQUE SPECIFICATIONS
Fluid Specifications See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button.
Flywheel/Flex Plate Torque 59 Ft. Lbs. (80 N.m)
Fuel System
Fuel Filter Location Lifetime fuel filter (serviced as part of the Fuel Pump module).
Fuel Filter R & I FUEL PUMP MODULE
Pressure Release Procedure FUEL SYSTEM PRESSURE RELEASE
Pressure Specification FUEL PRESSURE -- CARS
Fuel Pressure Test Procedure FUEL SYSTEM PRESSURE TEST
Ignition
Firing Order & Cylinder Identification FIRING ORDER & CYLINDER IDENTIFICATION
Spark Plugs
3.5L GTDI
Type Motorcraft CYSF-12F-3
Gap 0.032-0.038 In. (0.81-0.97 mm)
Torque 15 Ft. Lbs. (20 N.m)
3.7L (4V)
Type Motorcraft AYSF-22FM
Gap 0.051-0.057 In. (1.29-1.45 mm)
Torque 15 Ft. Lbs. (20 N.m)
Starting
Starter w/Torque SPECIFICATIONS
Wheel Alignment
Adjustment Specifications SPECIFICATIONS
Torque SPECIFICATIONS
Wheel & Tire
Wheel Lug Nut Torque 100 Ft. Lbs. (135 N.m)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.