Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Lincoln MKS Base, AWDFACTORY OEM SERVICE PROCEDURE
DTC Index: Seats
DRIVER DOOR MODULE (DDM) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| B1342 | ECU is Faulted | CLEAR the DTCs. REPEAT the self-test. If DTC B1342 is retrieved again, INSTALL a new DSM. REFER to DRIVER SEAT MODULE (DSM) . TEST the system for normal operation. |
| B1534 | Memory 1 Switch Circuit Short to Ground | GO to PINPOINT TEST G . |
| B1538 | Memory 2 Switch Circuit Short to Ground | GO to PINPOINT TEST G . |
| B2477 | Module Configuration Failure |
NOTE:
This DTC indicates PMI has not been done to a newly installed module or configuration data has been lost. Presence of this DTC alone does not prevent basic seat operation from the seat control switch. CARRY OUT Programmable Module Installation (PMI) on the DDM. REFER to
MODULE CONFIGURATION SYSTEM
article. REPEAT the self-test. If PMI is successful, the DTC will not be present. |
| U0140 | Lost Communication With Body Control Module (GEM) |
NOTE:
The SJB may also be identified as the GEM. CLEAR the DTC. REPEAT the self-test. If the DTC is retrieved again, REFER to
MODULE COMMUNICATIONS NETWORK
article to diagnose the MS-CAN concern. |
| U2050 | No Application Present | INSTALL a new DDM. REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS article. REPEAT the self-test. |
| All Other DTCs | - | REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS article. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
