2010 Lincoln MKT EcoBoostFACTORY OEM SERVICE PROCEDURE

DTC Table

NOTE: Some modules on this vehicle utilize a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
DTC TABLE

DTC Description Source Action
B2477 Module Configuration Failure ABS module
Dual Climate Controlled Seat Module (DCSM)
Driver Door Module (DDM)
Driver Seat Module (DSM)
Parking Aid Module (PAM)
Restraints Control Module (RCM)
Smart Junction Box (SJB)
CARRY OUT Programmable Module Installation (PMI). REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
B2900 VINĀ  Mismatch 4X4 control module The PCM Vehicle Identification Number (VIN) is not correct. CARRY OUT PMIĀ  for the PCM. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
B2900 VINĀ  Mismatch ABS module
RCMĀ 
CARRY OUT PMIĀ  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
P0602 Powertrain Control Module Programming Error PCM CARRY OUT PMIĀ  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
P0605 Internal Control Module Read Only Memory (ROMĀ  ) Error PCM CARRY OUT PMIĀ  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
P1639 Vehicle ID Block Corrupted, Not Programmed PCM CARRY OUT PMIĀ  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
P163E Transmission Control Module Programming Error PCM CARRY OUT PMIĀ  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
P163F Transmission ID Block Corrupted, Not Programmed PCM CARRY OUT PMIĀ  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
U0300 Internal Control Module Software Incompatibility PCM CARRY OUT PMIĀ  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
U201A:51 Control Module Main Calibration Data: Missing Calibration Front Controls Interface Module (FCIM) INSTALL a new FCIMĀ  . REFER to INFORMATION AND ENTERTAINMENT SYSTEMS .
U201A:51 Control Module Main Calibration Data: Missing Calibration Audio Control Module (ACM)
Audio Digital Signal Processing (DSP) module
CARRY OUT PMIĀ  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
U201A:54 Control Module Main Calibration Data: Not Programmed Headlamp Control Module 2 (HCM-2) CARRY OUT PMIĀ  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
U2050 No Application Present 4X4 control module INSTALL a new 4X4 control module. REFER to FOUR-WHEEL DRIVE (4WD) SYSTEMS .
U2050 No Application Present ABS module
DCSMĀ 
DDMĀ 
DSMĀ 
Liftgate/Trunk Module (LTM)
RCMĀ 
Steering Angle Sensor Module (SASM)
SJBĀ 
CARRY OUT PMIĀ  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
U2050 No Application Present Occupant Classification System Module (OCSM) INSTALL a new OCSMĀ  . REFER to REMOVAL AND INSTALLATION .
U2051 One or More Calibration Files Missing/Corrupt 4X4 control module INSTALL a new 4X4 control module. REFER to FOUR-WHEEL DRIVE (4WD) SYSTEMS .
U2051 One or More Calibration Files Missing/Corrupt LTMĀ  CARRY OUT PMIĀ  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
U2051 One or More Calibration Files Missing/Corrupt PAMĀ  INSTALL a new PAMĀ  . REFER to PARKING AID .
U2100:00 Initial Configuration Not Complete: No Sub Type Information ACMĀ 
Audio DSPĀ  module
HCM-2Ā 
IPCĀ 
Side Obstacle Detection Control Module - Left (SOD-L)
Side Obstacle Detection Control Module - Right (SOD-R)
CARRY OUT PMIĀ  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
U2100:00 Initial Configuration Not Complete: No Sub Type Information APIMĀ  CARRY OUT APIMĀ  programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMINGĀ .
U2100:55 Initial Configuration Not Complete: Not Configured Remote Function Actuator (RFA) module CARRY OUT PMIĀ  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
U2101:00 Control Module Configuration Incompatible: No Sub Type Information ACMĀ 
Audio DSPĀ  module
CARRY OUT PMIĀ  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)Ā .
U2101:00 Control Module Configuration Incompatible: No Sub Type Information APIMĀ  CARRY OUT APIMĀ  programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMINGĀ .
U3000:55 Control Module: Not Configured HVAC module INSTALL a new HVAC module. REFER to CLIMATE CONTROL .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.