Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Lincoln ZephyrFACTORY OEM SERVICE PROCEDURE
Remote Keyless Entry Keypad Code Programming
NOTE:
To associate a memory configuration to a personal entry code, refer to the owner's literature.
- Enter the permanent factory remote keyless entry (RKE) keypad code.
- Press the 1/2 button within 5 seconds to activate the programming mode. Holding the 1/2 button for more than 2 seconds after activation erases all the customer codes. The existing code does not need to be erased to program new a code.
- Within 5 seconds, enter the new 5-digit RKE keypad code. The doors lock and unlock to confirm the new code is programmed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.