Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLINCOLN2006NAVIGATOR 4WD V8-5.4L VIN 5REPAIR AND DIAGNOSISBODY AND FRAMEBODY CONTROL SYSTEMSBODY CONTROL MODULESERVICE AND REPAIRDRIVER SEAT MODULE (DSM)
2006 Lincoln Navigator 4WD V8-5.4L VIN 5
Driver Seat Module (DSM)
2006 Lincoln Navigator 4WD V8-5.4L VIN 5SECTION Driver Seat Module (DSM)
DRIVER SEAT MODULE (DSM)
Removal and Installation
CAUTION:
- Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
- Prior to the removal of the module, it is necessary to upload module configuration information to the appropriate diagnostic equipment. This information needs to be downloaded into the new module once installed.
1. NOTE: The module is accessed with the seat fully in the UP position.
Position the driver seat module forward to remove it from the bracket.
2. Disconnect the battery.
3. Disconnect the electrical connectors and remove the DSM.
4. CAUTION: Once the module is installed it is necessary to download the module configuration information from the diagnostic tool into the new module.
To install, reverse the removal procedure.
Removal and Installation
CAUTION:
- Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
- Prior to the removal of the module, it is necessary to upload module configuration information to the appropriate diagnostic equipment. This information needs to be downloaded into the new module once installed.
1. NOTE: The module is accessed with the seat fully in the UP position.
Position the driver seat module forward to remove it from the bracket.
2. Disconnect the battery.
3. Disconnect the electrical connectors and remove the DSM.
4. CAUTION: Once the module is installed it is necessary to download the module configuration information from the diagnostic tool into the new module.
To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.