Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2006 Lincoln LSFACTORY OEM SERVICE PROCEDURE

Automatic Transaxle-Transmission: Disassembly: Transmission

SPECIAL TOOL CHART

Courtesy of FORD MOTOR CO.	Remover, Input Shaft Oil Seal 308-375
Courtesy of FORD MOTOR CO.	Remover, Transmission Fluid Pump 307-397
Courtesy of FORD MOTOR CO.	Holding Fixture, Transmission 307-003 (T57L-500-B)
Courtesy of FORD MOTOR CO.	Slide Hammer 100-001 (T50T-100-A)
Courtesy of FORD MOTOR CO.	Remover, Torque Converter Fluid Seal 307-309 (T94P-77001-BH)
Courtesy of FORD MOTOR CO.	Compressor, Servo Cover 307-402
Courtesy of FORD MOTOR CO.	Handle, Torque Converter 307-091 (T81P-7902-C)
Courtesy of FORD MOTOR CO.	Remover, Output Shaft Flange 307-523

NOTE: Tag and identify all parts for reassembly.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.