2006 Lincoln LSFACTORY OEM SERVICE PROCEDURE

Fluid Pump: Disassembly

  1. Remove the fluid pump gasket, fluid pump seal ring and the No. 1 thrust washer.
    1. Remove and discard the fluid pump gasket.
    2. Remove and discard the fluid pump seal ring (square cut).
    3. Remove and tag the No. 1 thrust washer.
      Fig 1: Identifying Fluid Pump Gasket, Fluid Pump Seal Ring And Thrust Washer
      G04691438Courtesy of FORD MOTOR CO.
  2. Remove the fluid pump support seal ring.
    Fig 2: Locating Fluid Pump Support Seal Ring
    G04691439Courtesy of FORD MOTOR CO.
  3. Remove the seal rings.
    Fig 3: Locating Seal Rings
    G04691440Courtesy of FORD MOTOR CO.
  4. Remove the fluid pump housing.
    Fig 4: Locating Fluid Pump Housing Screws
    G04691441Courtesy of FORD MOTOR CO.
  5. NOTE: A rough casting on the pump surface crescent is not a flaw.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.