2006 Lincoln LSFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
Power Steering System 
Air conditioning compressor bolts 25 18 -
Cooler-to-radiator bolts 10 - 89
Fluid cooler-to-radiator bolts 10 - 89
Inner tie rod 100 74 -
Intermediate shaft slider bolt 35 26 -
Intermediate shaft-to-steering gear bolt 35 26 -
Lower reservoir isolator bolt 10 - 89
Power steering line retainer bracket bolt 10 - 89
Pressure line fitting 33 24 -
Pump bolts (upper/lower) 25 18 -
Radiator hose tube-to-engine bolts 10 - 89
Steering line clamp plate bolt 10 - 89
Steering gear-to-crossmember nuts and bolts 90 66 -
Tie-rod end jam nut 55 41 -
Tie-rod end nut 80 59 -
Upper reservoir isolator bolt 4 - 35
Variable assist power steering (VAPS) actuator bolts 3 - 27
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.