Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Lincoln LSFACTORY OEM SERVICE PROCEDURE
Parking Aid System DTCS
PARKING AID SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Source | Action |
|---|---|---|---|
| B1299 | Power Supply Sensor Circuit Short to Ground | Parking Aid Module | Go To PINPOINT TEST C . |
| B1342 | ECU is Defective | Parking Aid Module | CLEAR the DTCs. REPEAT the parking aid module self-test. If DTC B1342 is retrieved again, INSTALL a new parking aid module. REFER to PARKING AID MODULE . CLEAR the DTCs. REPEAT the self-test. |
| B1627 | PRNDL Reverse Input Circuit Failure | Parking Aid Module | Go To PINPOINT TEST F . |
| B2844 | Ignition Voltage Out of Range | Parking Aid Module | CLEAR the DTCs. REPEAT the parking aid module self-test. If DTC B2844 is retrieved again, REFER to CHARGING SYSTEM - GENERAL INFORMATION for charging system diagnosis. |
| C1700 | Left Rear Sensor Circuit Failure or Blockage | Parking Aid Module | CLEAN the rear bumper and sensors with high-pressure water. CLEAR the DTCs. REPEAT the self-test. If the DTC resets, Go To PINPOINT TEST C . |
| C1703 | Right Rear Sensor Circuit Failure or Blockage | Parking Aid Module | CLEAN the rear bumper and sensors with high-pressure water. CLEAR the DTCs. REPEAT the self-test. If the DTC resets, Go To PINPOINT TEST C . |
| C1983 | Radar Sensor Fault | Parking Aid Module | CLEAN the rear bumper and sensors with high-pressure water. CLEAR the DTCs. REPEAT the self-test. If the DTC resets, INSTALL a new parking aid radar sensor. REFER to PARKING AID MODULE . CLEAR the DTCs. REPEAT the self-test. |
| C1984 | Radar Sensor Circuit Failure | Parking Aid Module | Go To PINPOINT TEST D . |
| C1985 | Parking Aid Disable Switch Stuck Low | Parking Aid Module | Go To PINPOINT TEST E . |
| C1992 | Vehicle Speed Circuit Failure | Parking Aid Module | Go To PINPOINT TEST G . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
