2006 Lincoln LSFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
Intake manifold bolts(1) - - -
Fuel rail bolts 10 - 89
Radio interference capacitor nuts 10 - 89
Wiring harness retainer nuts 10 - 89
Engine appearance cover bracket nuts 6 - 53
Cross-vehicle brace bolts 20 15 -
Valve cover bolts(1) - - -
Fuel hose bracket bolt 11 8 -
Power steering pump reservoir upper bolt 6 - 53
Power steering pump reservoir lower bolt 12 9 -
Crankshaft pulley bolt (1) - - -
Flexplate bolts (1) - - -
Engine front cover bolts (1) - - -
Power steering pump bracket bolts 25 18 -
Power steering pump bolts 25 18 -
Lower radiator hose bracket nut 10 - 89
Secondary timing chain tensioner bolts 11 8 -
Timing chain guide bolts 11 8 -
Timing chain tensioner arm bolts 11 8 -
Exhaust camshaft sprocket bolts (1) - - -
Variable cam timing (VCT) unit bolts (1) - - -
Primary timing chain tensioner bolts 11 8 -
VCT bush carrier bolts 20 15 -
VCT bush carrier nuts 10 - 89
Crankshaft position (CKP) sensor bolt 10 - 89
Camshaft bearing cap bolts (1) - - -
Spark plugs 27 20 -
Oil pan drain plug 23 17 -
Oil pan bolts (1) - - -
Oil pump bolts (1) - - -
Oil pump screen and pickup tube bolts 12 9 -
Oil cooler assembly 60 44 -
Oil filter(2) - - -
Oil level indicator tube nut 6 - 53
Oil filter adapter bolts (1) - - -
Exhaust manifold bolts (1) - - -
Exhaust manifold heat shield bolts 3 - 27
Exhaust manifold heat shield stud bolts 50 37 -
Exhaust gas recirculation (EGR) tube flange nuts 20 15 -
Engine mount-to-frame nuts (N621942-S441) 55 41 -
Engine mount-to-bracket nuts 50 37 -
Engine mount bracket-to-cylinder block bolts 46 34 -
Engine mount bracket-to-cylinder block stud bolts 46 34 -
Transmission cooling tube bracket nut 10 - 89
Power steering tube bracket nut 10 - 89
Cylinder block drain plug 50 37 -
Cylinder head bolts (1) - - -
Throttle body adapter bolts 10 - 89
EGR system module bolts 25 18 -
EGR system module tube fitting nut 40 30 -
Ignition coil bolts 5 - 44
Ignition coil cover bolts 10 - 89
Accessory drive belt idler pulley bolt 25 18 -
Accessory drive belt tensioner bolt 25 18 -
Engine-to-transmission bolts 47 35 -
Transmission cooler tube nuts 35 26 -
A/C compressor bolts 25 18 -
Crossmember bolts (W708091-S439) 90 66 -
Crossmember I-brace bolts 30 22 -
Transmission support bolts 55 41 -
Torque converter nuts (N800750-S437) 48 35 -
Starter motor wiring (large nut) 12 9 -
Starter motor wiring (small nut) 6 - 53
Starter motor ground cable 25 18 -
Steering coupling bolt 35 26 -
Steering shaft bolt 30 22 -
Shift cable bracket bolts 10 - 89
Lower strut mount bolts 175 129 -
Upper ball joint nuts 90 66 -
Stabilizer bar link nuts 55 41 -
Front brake caliper bolts 35 26 -
A/C high pressure hose 8 - 71
Driveshaft bolts 81 60 -
Bulkhead electrical connectors 6 - 53
Ground strap bolt 10 - 89
Radiator support bracket bolts 10 - 89
Knock sensor (KS) bolts 20 15 -
Oil sump bolts (1) - - -
Coolant pump bolts (1) - - -
Starter motor bolts (1) -- - -
Coolant inlet housing bolts 10 - 89
Generator bracket bolts 42 31 -
Generator bolts and nut 40 30 -
Generator electrical connector nut 8 - 71
Coolant pump pulley bolts 10 - 89
Camshaft position (CMP) sensor bolt 10 - 89
Cylinder head temperature (CHT) sensor 22 16 -
(1) Refer to procedure for staged torque.
(2) Install oil filter until seal makes contact. Tighten an additional 270 degrees.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.