Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lincoln Aviator AWDFACTORY OEM SERVICE PROCEDURE
Suspension System DTCS
TIRE PRESSURE MONITOR SYSTEM (TPMS) MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Source | Action |
|---|---|---|---|
| B1342 | ECU is Defective | TPMS Module | INSTALL a new tire pressure monitor module. REFER to WHEELS & TIRES . |
| B2477 | Module Configuration Failure/Mismatch | TPMS Module | REFER to MODULE CONFIGURATION . |
| B2849 | Horn Output Relay Circuit Open | TPMS Module | GO to PINPOINT TEST D . |
| B2868 | Left Front Tire Pressure Sensor Fault | TPMS Module | REFER to MODULE CONFIGURATION . |
| B2869 | Right Front Tire Pressure Sensor Fault | TPMS Module | REFER to MODULE CONFIGURATION . |
| B2870 | Right Rear Tire Pressure Sensor Fault | TPMS Module | REFER to MODULE CONFIGURATION . |
| B2871 | Left Rear Tire Pressure Sensor Fault | TPMS Module | REFER to MODULE CONFIGURATION . |
| B2872 | Tire Pressure Sensor Fault | TPMS Module | GO to PINPOINT TEST E . |
| C2780 | ECU in Manufacturing Mode | TPMS Module | REFER to MODULE CONFIGURATION . |
| U1041 | SCP Invalid or Missing Data for Vehicle Speed | SCP | REFER to MODULE CONFIGURATION . |
| U1262 | SCP Communication Bus Fault | SCP | REFER to MODULE CONFIGURATION . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
