Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lincoln Aviator AWDFACTORY OEM SERVICE PROCEDURE
Instrument Cluster DTCS
INSTRUMENT CLUSTER DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Source | Action |
|---|---|---|---|
| B1201 | Fuel Sender Circuit Failure | Instrument Cluster | GO to PINPOINT TEST B . |
| B1204 | Fuel Sender Circuit Short To Ground | Instrument Cluster | GO to PINPOINT TEST B . |
| B1209 | Instrument Cluster Switch 2 Assembly Circuit Failure | Instrument Cluster | CHECK for correct assembly of the message center inner and outer bezels. If the bezels are correctly assembled, INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . |
| B1317 | Battery Voltage High | Instrument Cluster | REFER to CHARGING SYSTEM - GENERAL INFORMATION to continue diagnosis of the charging system. |
| B1318 | Battery Voltage Low | Instrument Cluster | REFER to CHARGING SYSTEM - GENERAL INFORMATION to continue diagnosis of the charging system. |
| B1342 | ECU is Defective | Instrument Cluster | INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . TEST the system for normal operation. |
| B1360 | Ignition Run/Acc Circuit Open | Instrument Cluster | GO to PINPOINT TEST A . |
| B2143 | NVM Memory Failure | Instrument Cluster | GO to PINPOINT TEST V |
| C1284 | Oil Pressure Switch Failure | Instrument Cluster | GO to PINPOINT TEST Q . |
| U1027 | Invalid or Missing Data for Engine RPM | Instrument Cluster | GO to PINPOINT TEST E . |
| U1041 | Invalid or Missing Data for Vehicle Speed | Instrument Cluster | REFER to INTRODUCTION - GASOLINE MODELS to continue diagnosis. |
| U1073 | Invalid or Missing Data for Engine Coolant | Instrument Cluster | REFER to INTRODUCTION - GASOLINE MODELS to continue diagnosis. |
| U1123 | Invalid or Missing Data for Odometer | Instrument Cluster | REFER to INTRODUCTION - GASOLINE MODELS to continue diagnosis. |
| U1249 | SCP Invalid or Missing Data for Time/Date | Instrument Cluster | REFER to INTRODUCTION - GASOLINE MODELS to continue diagnosis. |
| U1262 | SCP Communication Fault | Instrument Cluster | GO to PINPOINT TEST A . |
| U1950 | UBP Communication Fault | Instrument Cluster | REFER to INTRODUCTION - GASOLINE MODELS to continue diagnosis. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
