Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Lincoln Town Car Protection SeriesFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Front safety belt retractor and pretensioner bolt | 40 | 30 | - |
| Rear outboard safety belt retractor bolt | 40 | 30 | - |
| Rear center safety belt retractor bolt | 40 | 30 | - |
| Front safety belt-to-floor pan anchor bolt | 40 | 30 | - |
| Rear safety belt-to-floor pan anchor bolt | 48 | 35 | - |
| Rear safety belt dual buckle assembly-to-floor pan bolt | 48 | 35 | - |
| Rear safety belt retractor, belt anchor and buckle assembly-to-floor pan bolt | 48 | 35 | - |
| Height adjuster bolt | 40 | 30 | - |
| Front safety belt guide nut | 40 | 30 | - |
| Rear safety belt guide bolt | 40 | 30 | - |
| Front safety belt buckle-to-seat nut | 40 | 30 | - |
| Front center safety belt-to-driver seat track nut | 80 | 59 | - |
| Front center safety belt buckle-to-passenger seat track nut | 80 | 59 | - |
| Child safety seat tether anchor bolt | 20 | 15 | - |
| Child safety seat tether anchor (LATCH) bolt | 20 | 15 | - |
| Passenger airbag module bolt (glovebox) | 9 | - | 80 |
| Passenger airbag module bolt (under trim panel) | 3 | - | 27 |
| Side impact sensor bolt | 9 | 12 | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.