Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Lincoln Navigator RWDFACTORY OEM SERVICE PROCEDURE
Anti-Theft Systems DTCS
ANTI-THEFT SYSTEMS DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Source | Perform Test |
|---|---|---|---|
| B1213 | Anti-Theft Number of Programmed Keys is Below Minimum | PCM | GO to PINPOINT TEST F: ANTI-THEFT NUMBER OF PROGRAMMED KEYS IS BELOW MINIMUM . |
| B2431 | Key Program Failure (Defective Key or Transceiver) | PCM | VERIFY if using correct PATS key, if defective USE new key. |
| B1342 | ECU is Defective (EEPROM in PCM not working) | PCM | INSTALL a new PCM. Refer to ELECTRONIC ENGINE CONTROLS . |
| B2103 | Antenna Not Connected | PCM | GO to PINPOINT TEST A: NO ANTENNA DETECTED . |
| B1600 | PATS Ignition Key Transponder Signal is Not Received | PCM | GO to PINPOINT TEST B: PATS IGNITION KEY TRANSPONDER SIGNAL IS NOT RECEIVED . |
| B1601 | PATS Received Incorrect Key-Code From Ignition Key Transponder | PCM | GO to PINPOINT TEST C: PATS RECEIVED INCORRECT KEY-CODE FROM IGNITION KEY TRANSPONDER . |
| B1602 | PATS Received Invalid Format of Key-Code From Ignition Key Transponder | PCM | GO to PINPOINT TEST D: PATS RECEIVED INVALID FORMAT OF KEY-CODE FROM IGNITION KEY TRANSPONDER . |
| B1681 | PATS Transceiver Module Signal is Not Received | PCM | GO to PINPOINT TEST E: THE PATS TRANSCEIVER MODULE SIGNAL IS NOT RECEIVED . |
| - | All other DTCs | PCM | REFER to MULTIFUNCTION ELECTRONIC MODULE . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
