Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Lincoln Navigator 4WDFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft |
|---|---|---|
| Bolts retaining the skid plate to the frame (4x4 only) | 15 | 11 |
| Fluid cooler tube-to-transmission fluid tube connector assembly (4R70W) | 27 | 20 |
| Fluid cooler tube-to-cooler line case fitting (4R100) | 27 | 20 |
| Front cooler line case fitting-to-transmission case (4R100) | 30 | 22 |
| Rear cooler line case fitting-to-transmission case (4R100) | 37 | 27 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
