Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Lincoln LS 3.0 SFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System (ABS) Module
- Disconnect the battery.
- Remove the parts in the order indicated in the following illustration and table.
- To install, reverse the removal procedure.
Item 3: Anti-Lock Brake System (ABS) Module Removal Note
- Position the battery junction box (BJB) aside.
- Release the clips.
- Position the BJB aside.
Item 3: Anti-Lock Brake System (ABS) Module Installation Note
- Use the diagnostic tool to reconfigure the ABS module. For additional information, refer to MODULE COMMUNICATIONS NETWORK .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.