2004 Lincoln Aviator RWDFACTORY OEM SERVICE PROCEDURE

Shock Absorber And Spring Assembly: Notes

  1. Remove the shock absorber and spring assembly. For additional information, refer to SHOCK ABSORBER AND SPRING ASSEMBLY - FRONTΒ  or SHOCK ABSORBER AND SPRING ASSEMBLY - REARΒ .
  2. Using a suitable spring compressor, compress the spring until the tension is released from the shock absorber.
    Fig 1: Compressing Spring Until Tension Is Released From Shock Absorber
    G03262926Courtesy of FORD MOTOR CO.
  3. Disassemble the parts in the order indicated in the following illustration and table.
    Fig 2: Identifying Shock Absorber And Spring Assembly Components
    G03262927Courtesy of FORD MOTOR CO.
  4. To assemble, reverse the disassembly procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.