2004 Lincoln Aviator RWDFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
Camshaft sprocket bolt (1) - - -
Connecting rod bolt (1) - - -
Engine front cover bolt (1) - - -
Drive belt tensioner bolts 25 18 -
Cylinder head bolt (1) - - -
Pulley to crankshaft bolt (1) - - -
EGR valve to intake manifold 25 18 -
Exhaust manifold studs 12 9 -
Lower intake manifold-to-cylinder head bolt (1) - - -
Main bearing cap bolt (1) - - -
Oil filter adapter bolt 25 18 -
Heater coolant outlet-to-cylinder head bolts 10 - 89
Oil pump screen cover and tube-to-oil pump bolt 10 - 89
Oil pan-to-cylinder block bolt (1) - - -
Oil pan-to-engine front cover bolts (1) - - -
Oil pump-to-cylinder block bolt 10 - 89
Oil pump screen and pickup tube-to-main bearing cap stud spacer bolt 25 18 -
Water pump pulley bolts 25 18 -
Valve cover bolts and studs 10 - 89
Water pump-to-cylinder block bolts 25 18 -
EGR valve to exhaust manifold tube nuts 40 30 -
Power steering pump to engine 25 18 -
Outlet heater water hose to engine front cover bolts 25 18 -
Camshaft cap cluster to cylinder head 19 14 -
Timing chain tensioner bolts-primary 25 18 -
Timing chain tensioner bolts-secondary 10 - 89
A/C compressor studs 25 18 -
Ignition coil cover bolts 10 - 89
Generator mounting bracket retainers 10 - 89
Oil level indicator tube retainer 10 - 89
Primary timing chain guide-to-engine bolts 10 - 89
Oil pump screen and pickup tube spacer to main bearing stud 25 18 -
Accelerator cable bracket 10 - 89
Belt idler pulley bolt 25 18 -
Subframe brace nuts 41 30 -
EGR system module heat shield bolts 10 - 89
(1) Refer to the procedure.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.