2004 Lincoln Aviator AWDFACTORY OEM SERVICE PROCEDURE

Spring Lock Coupling: Connect

WARNING: This page is about a different car, the 2003 Lincoln Aviator. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the A/C tube lock coupling spring.
    Fig 1: Installing A/C Tube Lock Coupling Spring
    G01636964Courtesy of FORD MOTOR CO.
  2. Lubricate the inside of the coupling with PAG Refrigerant Compressor Oil (R-134a Systems) or equivalent.
    Fig 2: Lubricating Inside Of Coupling With PAG Refrigerant Compressor Oil
    G01636965Courtesy of FORD MOTOR CO.
  3. CAUTION: Use only the new O-ring seals. The use of any O-ring seals other than those specified in the Ford Master Parts Catalog may result in intermittent leakage during vehicle operation.
  4. Install the O-ring seals.
    • Lubricate the O-ring seals with PAG Refrigerant Compressor Oil (R-134a Systems) or equivalent.
      Fig 3: Install And Lubricate O-Ring Seals
      G01636966Courtesy of FORD MOTOR CO.
  5. Connect the spring lock coupling fittings with a twisting motion until the A/C tube lock coupling spring snaps over the flared end of the female fitting.
    Fig 4: Connecting Spring Lock Coupling Fittings
    G01636967Courtesy of FORD MOTOR CO.
  6. Install the A/C tube lock coupling clip.
    Fig 5: Installing A/C Tube Lock Coupling Clip
    G01636968Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.