2004 Lincoln Aviator AWDFACTORY OEM SERVICE PROCEDURE

Spring Lock Coupling: Cleaning

WARNING: This page is about a different car, the 2003 Lincoln Aviator. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fabricate a cleaning tool from a 1/8 inch diameter brazing rod.
    Fig 1: Cleaning Tool Dimensions
    G01636959Courtesy of FORD MOTOR CO.
  2. Cut an abrasive pad from maroon colored 3M Scotch Brite® with the dimensions corresponding to the coupling size.
    Fig 2: Coupling Size Dimensions Table
    G01636960Courtesy of FORD MOTOR CO.
  3. Assemble the pad to the tool.
    Fig 3: Assembling Pad To Tool
    G01636961Courtesy of FORD MOTOR CO.
  4. Coat the abrasive pad with PAG Refrigerant Compressor Oil (R-134a Systems) or equivalent.
  5. Roll the pad on the tool and install it in a variable speed drill motor.
  6. CAUTION: Maintain low speed drill rotation when inserting or removing the cleaning tool to prevent axial scratches which may cause future leaks.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.