Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Lincoln Aviator AWDFACTORY OEM SERVICE PROCEDURE
Dual/Electronic Automatic Temperature Control (DATC) Module Diagnostic Trouble Code (DTC) Index
WARNING: This page is about a different car, the 2003 Lincoln Aviator. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
All DTCs can be retrieved as an on-demand (hard fault) or continuous (intermittent fault) fault. If a continuous (intermittent) fault, the degrees Celsius symbol (°C) will be displayed in addition to the DTCs.
DUAL/ELECTRONIC AUTOMATIC TEMPERATURE CONTROL (DATC) MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Perform Test |
|---|---|---|
| B2266 | LH Blend Door Failure Or Short | Go To Pinpoint Test A |
| B2267 | RH Blend Door Failure Or Short | Go To Pinpoint Test A |
| B1251 | A/C In-Vehicle Temperature Sensor Open Circuit | Go To Pinpoint Test B |
| B1253 | A/C In-Vehicle Temperature Sensor Circuit Short To Ground | Go To Pinpoint Test B |
| B1255 | A/C Ambient Temperature Sensor Open Circuit | Go To Pinpoint Test C |
| B1257 | A/C Ambient Temperature Sensor Circuit Short To Ground | Go To Pinpoint Test C |
| B1259 | A/C Solar Radiation Sensor Open Circuit | Go To Pinpoint Test D |
| B1261 | A/C Solar Radiation Sensor Circuit Short To Ground | Go To Pinpoint Test D |
| B2268 | Steering Wheel Control Switch Open Circuit | Go To Pinpoint Test E |
| B2269 | Steering Wheel Control Switch Circuit Short To Ground | Go To Pinpoint Test E |
| B2477 | Module Not Configured | Configure DATC Module |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
