2004 Lincoln Aviator AWDFACTORY OEM SERVICE PROCEDURE

Air Conditioning: Notes

WARNING: This page is about a different car, the 2003 Lincoln Aviator. However, it is still accessible from the selected car via links, so may be relevant.

The air conditioning system components are:

  • A/C compressor (19703)
  • A/C condenser core (19712)
  • A/C evaporator core (part of 19850 assembly)
  • receiver/drier (19959)
  • connecting refrigerant lines
  • thermostatic expansion valve assembly(19849)
  • A/C thermostatic switch
  • Refrigerant containment switch (19D594)
  • A/C compressor pressure relief valve (19D644)
  • low charge protection switch (19E561)

    The refrigerant system incorporates an A/C compressor controlled by the powertrain control module (PCM) through an A/C clutch relay.

  • The A/C compressor clutch will only be engaged by the PCM if all of the following conditions are met:
  • The climate control assembly is set to a mode which provides an A/C request to the PCM.
  • The A/C thermostatic switch is reading an acceptable temperature (4Β°C/39.5Β°F).
  • The refrigerant containment switch is not open due to excessive pressure in the high side of the refrigerant system.
  • The low charge protection switch is not open due to insufficient low side refrigerant system pressure.
  • The A/C compressor relay is switched to the closed position by the PCM.
  • The engine coolant temperature is not excessively high.
  • The PCM has not detected a wide open throttle (WOT) condition.

An A/C compressor pressure relief valve is installed in the compressor manifold and tube assembly (19D734) to protect the refrigerant system against excessively high refrigerant pressures.

Refrigerant flow into the evaporator core is metered by a thermostatic expansion valve.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.