2003 Lincoln Navigator RWDFACTORY OEM SERVICE PROCEDURE

Anti-Theft Systems DTCS

ANTI-THEFT SYSTEMS DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Source Perform Test
B1213 Anti-Theft Number of Programmed Keys is Below Minimum PCM Go To PINPOINT TEST F .
B1342 ECU is Defective (EEPROM in PCM not working) PCM INSTALL a new PCM. REFER to REMOVAL & INSTALLATION in ENGINE PERFORMANCE.
B1600 PATS Ignition Key Transponder Signal is Not Received PCM Go To PINPOINT TEST B .
B1601 PATS Received Incorrect Key-Code From Ignition Key Transponder PCM Go To PINPOINT TEST C .
B1602 PATS Received Invalid Format of Key-Code From Ignition Key Transponder PCM Go To PINPOINT TEST D .
B1681 PATS Transceiver Module Signal is Not Received PCM Go To PINPOINT TEST E .
B2103 Antenna Not Connected PCM Go To PINPOINT TEST A .
B2431 Key Program Failure (Defective Key or Transceiver) PCM VERIFY if using correct PATS key, if defective USE new key.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.