2003 Lincoln LS 3.0 SFACTORY OEM SERVICE PROCEDURE

Power Windows DTCS

DRIVER DOOR MODULE (DDM) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Source Action
B1342 ECU is Defective DDM CLEAR the DTC. REPEAT the self-test. If DTC B1342 is retrieved, INSTALL a new DDM. REFER to MODULE COMMUNICATIONS NETWORK . REPEAT the self-test.
B1416 Power Window LR Motor Circuit Short to Battery DDM Go To PINPOINT TEST J .
B1424 Power Window RR Motor Circuit Short to Battery DDM Go To PINPOINT TEST J .
B2360 Window Motor Control Output Circuit Failure DDM Go To PINPOINT TEST L .
B2477 Module Configuration Failure DDM REFER to MODULE COMMUNICATIONS NETWORK .
FRONT ELECTRONIC MODULE (FEM) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Source Action
B1342 ECU is Defective FEM CLEAR the DTC. REPEAT the FEM self-test. If DTC B1342 is retrieved, INSTALL a new FEM. REFER to MODULE COMMUNICATIONS NETWORK . REPEAT the self-test.
B1676 Battery Pack Voltage Out of Range FEM REFER to GENERATORS & REGULATORS .
B2477 Module Configuration Failure FEM REFER to MODULE COMMUNICATIONS NETWORK .
REAR ELECTRONIC MODULE (REM) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Source Action
B1342 ECU is Defective REM CLEAR the DTC. REPEAT the REM self-test. If DTC B1342 is retrieved, INSTALL a new REM. REFER to MODULE COMMUNICATIONS NETWORK . REPEAT the self-test.
B1676 Battery Pack Voltage Out of Range REM REFER to GENERATORS & REGULATORS .
B2174 Window Driver Rear Remote Up Switch Short to Battery REM Go To PINPOINT TEST J .
B2178 Window Driver Rear Remote Down Switch Short to Battery REM Go To PINPOINT TEST J .
B2190 Window Passenger Rear Remote Up Switch Short to Battery REM Go To PINPOINT TEST J .
B2194 Window Passenger Rear Remote Down Switch Short to Battery REM Go To PINPOINT TEST J .
B2477 Module Configuration Failure REM REFER to MODULE COMMUNICATIONS NETWORK .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.