Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Lincoln ContinentalFACTORY OEM SERVICE PROCEDURE
Torque Converter: Notes
- A new torque converter must be installed if one or more of the following statements are true:
- A torque converter malfunction has been determined based on complete diagnostic procedures.
- Converter stud(s), impeller hub or bushing are damaged.
- Discoloration of the torque converter (due to overheating).
- The torque converter is found to be out of specification when performing one of the following torque converter checks:
- One-Way Clutch Check
- End Play Check
- Stator to Turbine Interference Check
- Stator to Impeller Interference Check
- Torque Converter Leak Check
- Evidence of transmission assembly or fluid contamination due to the following transmission or converter failure modes:
- Major Metallic Failure
- Multiple Clutches or Clutch Plate Failures
- Sufficient Component Wear which results in Metallic Contamination
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.