2001 Lincoln ContinentalFACTORY OEM SERVICE PROCEDURE

Cable Adjustment-Shift Control, Column Shift

NOTE: The shift control adjustment procedure must be performed in the order shown.
  1. Position the transaxle range selector lever in OVERDRIVE. Hang a 1.4 kg (3 lb) weight on the lever.
  2. Loosen the manual control lever-to-shift control cable retaining nut.
    Fig 1: Loosening Manual Control Lever-To-Shift Control Cable Retaining Nut
    G02169712
  3. Position the manual control lever in OVERDRIVE. Tighten the manual control lever-to-shift control cable nut.
    Fig 2: Tightening Manual Control Lever-To-Shift Control Cable Nut
    G02169713
  4. Remove the 1.4 kg (3 lb) weight. Check the operation of the transaxle in each transaxle range selector lever position.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.