Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Lincoln Town Car SignatureFACTORY OEM SERVICE PROCEDURE
Component Locations
WARNING: This page is about a different car, the 1999 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
For component locations refer to illustration and table. See COMPONENT LOCATIONSΒ table. See Fig 1 and Fig 2 .
COMPONENT LOCATIONS
| Component | Location | ||||
|---|---|---|---|---|---|
| Restraint Control Module (RAM) | Behind Passenger's Side Kick Panel | ||||
| Air Suspension/Electronic Variable Orifice (EVO) Steering Module (1) | Behind Instrument Panel Next To Glove Box | ||||
| Anti-Lock Brake System (ABS) Module | Right Front Of Engine Compartment, Under Upper Radiator Support | ||||
| Data Link Connector (DLC) | Below Left Side Of Instrument Panel, To Right Of Steering Column | ||||
| Driver's Door Module (DDM) | Inside Driver's Door | ||||
| Driver's Seat Module | Under Driver's Seat | ||||
| Electronic Automatic Temperature Control (EATC) Module | Center Of Instrument Panel | ||||
| Front Radio Control Unit (2) | Behind Center Of Instrument Panel, On Radio | ||||
| Powertrain Control Module (PCM) | In Engine Compartment On Left Side Of Firewall | ||||
| Lighting Control Module (LCM) | Behind Left Side Of Instrument Panel, To Right Of Steering Column | ||||
|
|||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
