Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Lincoln Town Car SignatureFACTORY OEM SERVICE PROCEDURE
Test G: Lighting Control Module Does Not Respond To NGS Tester
WARNING: This page is about a different car, the 2001 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch to LOCK position. Disconnect Lighting Control Module (LCM) 16-pin harness connector C221. LCM is located under center of instrument panel, to right of steering column. See Figure. Inspect harness connector for loose, damaged or corroded terminals. Repair harness connector as necessary and retest system for normal operation. If harness connector is okay, reconnect harness connector. Connect New Generation Star (NGS) tester to Data Link Connector (DLC). DLC is located below left side of instrument panel, to right of steering column. Turn ignition switch to RUN position and perform data link diagnostic test. See DATA LINK DIAGNOSTIC TESTΒ under SELF-DIAGNOSTIC SYSTEM. If NGS tester indicates LCM: NO RESPONSE ON CKT 914 (BUS +), go to next step. If NGS tester indicates LCM: NO RESPONSE ON CKT 915 (BUS -), go to step Β 3.
- Turn ignition switch to LOCK position. Disconnect NGS tester. Disconnect LCM harness connector C221. Measure resistance in Tan/Orange wire between LCM harness connector C221 terminal No. 20 and DLC terminal No. 2. See Figure and Fig 1 . If resistance is 5 ohms or more, repair open in Tan/Orange wire between LCM and DLC. If resistance is 5 ohms or less, replace LCM. Retest system for normal operation.
- Turn ignition switch to LOCK position. Disconnect NGS tester. Disconnect LCM harness connector C221. Measure resistance in Pink/Light Blue wire between LCM harness connector C221 terminal No. 28 and DLC terminal No. 10. See Figure and Fig 1 . If resistance is 5 ohms or more, repair open in Pink/Light Blue wire between LCM and DLC. If resistance is 5 ohms or less, replace LCM. Retest system for normal operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
