2000 Lincoln Town Car SignatureFACTORY OEM SERVICE PROCEDURE

Mirror Control Switch

Remove mirror control switch. Using an ohmmeter, check for continuity between indicated switch terminals with switch in appropriate position. See MIRROR CONTROL SWITCH TERMINAL IDENTIFICATIONΒ  table. See Fig 1 . Replace mirror control switch if it does not test as specified.

MIRROR CONTROL SWITCH TERMINAL IDENTIFICATION

Switch Position Continuity Between Terminals No.
Left Mirror
Up 3 & 9; 4 & 7
Down 3 & 4; 7 & 9
Left 1 & 3; 4 & 7
Right 1 & 7; 3 & 4
Right Mirror
Up 3 & 8; 4 & 7
Down 3 & 4; 7 & 8
Left 2 & 3; 4 & 7
Right 2 & 7; 3 & 4
Fig 1: Identifying Mirror Control Switch Terminals
G98E01563Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.