2000 Lincoln Town Car SignatureFACTORY OEM SERVICE PROCEDURE

Delayed Accessory Relay/Power Window Relay

NOTE: Delayed accessory relay is used on LTS, Signature, and Cartier models. Power window relay is used on Executive models.

Remove delayed accessory relay/power window relay from instrument panel fuse box. Using an ohmmeter, check continuity between relay terminals No. 85 and 86. See Fig 1 . Continuity should always exist. Check continuity between relay terminals No. 30 and 87a. Continuity should exist. Apply battery voltage and ground between relay terminals No. 85 and 86. Continuity should now exist between relay terminals No. 30 and 87. Replace relay if it does not test as specified.

Fig 1: Identifying Delayed Accessory Relay/Power Window Relay Terminals
G97D28186Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.