Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Lincoln Navigator RWDFACTORY OEM SERVICE PROCEDURE
Transfer Case DTCS
TRANSFER CASE DIAGNOSTIC TROUBLE CODE (DTC) INDEX
| DTC | Description | Perform Test |
|---|---|---|
| B1342 | ECU Defective | Clear DTCs and retest system. If DTC B1342 is still present, replace GEM. |
| B1483 | Brake Pedal Input Circuit Failure | C |
| B1485 | Brake Pedal Input Circuit Short | C |
| B2105 | Throttle Position Input Out Of Range Low | B |
| B2106 | Throttle Position Input Out Of Range High | B |
| C1107 | ABS Function Enabled Input Circuit Failure | A |
| P0500 | VSS Malfunction | C |
| P1812 | 4WD Mode Select Circuit Failure | A |
| P1815 | 4WD Mode Select Switch Short To Ground | C |
| P1820 | T/C LO-To-HI Shift Relay Open/Short To Ground | B |
| P1822 | T/C LO-To-HI Shift Relay Coil Short To Power | B |
| P1824 | 4WD Clutch Relay Circuit Failure | A |
| P1826 | 4WD Clutch Relay Short To Power | A |
| P1828 | T/C HI-To-LO Shift Relay Coil Circuit | B |
| P1830 | T/C HI-To-LO Shift Relay Coil Short To Power | B |
| P1836 | Front Drive Shaft Speed Sensor Circuit | A |
| P1837 | Rear Drive Shaft Speed Sensor Circuit | A |
| P1838 | T/C Shift Motor Circuit Failure | B |
| P1846 | T/C Contact Plate "A" Open Circuit Failure | B |
| P1850 | T/C Contact Plate "B" Open Circuit Failure | B |
| P1854 | T/C Contact Plate "C" Open Circuit Failure | B |
| P1858 | T/C Contact Plate "D" Open Circuit Failure | B |
| P1866 | T/C System Concern | B |
| P1867 | T/C Contact Plate General Circuit Failure | B |
| P1874 | Hall Effect Sensor Power Circuit Failure | A |
| P1875 | Hall Effect Sensor Power Circuit Short | B |
| P1891 | T/C Contact Plate Ground Return Open Circuit | B |
| B1892 | A4WD 4X4 Mechanical Lock Output Circuit Failure | B |
| B1893 | A4WD 4X4 Mechanical Lock Output Circuit Short To Power | B |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.
