Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Air Suspension Control Module
The air suspension control module is on the UBP communication network and controls the air compressor motor (through a solid state relay) and all system solenoids. The module also provides power to front and rear height sensors on four-wheel air suspension systems, or rear height sensors on the rear-wheel suspension systems. The module controls vehicle height adjustments by monitoring two height sensors, vehicle speed, a steering sensor, acceleration input, the door ajar signal, transfer case signals and the brake switch. The module also conducts all fail-safe and diagnostic strategies and contains self-test and communication software for testing the vehicle and module. For additional information, refer to STEERING COLUMN SWITCHES .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.