2000 Lincoln Navigator RWDFACTORY OEM SERVICE PROCEDURE

Power Window Master Switch

Remove master window control switch from vehicle. See POWER WINDOW SWITCHΒ  under REMOVAL & INSTALLATION. Check continuity between specified terminals while operating switch to specified position. See MASTER SWITCH TESTINGΒ  table. See Fig 1 . Check continuity between appropriate master window switch connector and terminals with switch in appropriate position. Continuity between harness connector C510 terminals No. 1 and 2 (switch illumination circuit) should exist at all times. If continuity is not as specified, replace switch.

MASTER SWITCH TESTING

Switch Position Connector Continuity Between Terminals No.
Left Front
Down C509 2 & 7
Up C509 2 & 6
Right Front
Down C509 2 & 3
Up C509 2 & 4
Left Rear
Down C510 2 & 6
Up C510 2 & 7
Right Rear
Down C510 2 & 4
Up C510 2 & 5
Fig 1: Identifying Power Window Master Switch Terminals
G97B28192Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.