2000 Lincoln LS 3.9 AFACTORY OEM SERVICE PROCEDURE

Power Memory Mirrors DTCS

DRIVER'S DOOR MODULE (DDM) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Perform Test
B1342 DDM Defective Using NGS tester, retrieve and document continuous DTCs. Clear all DTCs.
Perform Driver's Door Module (DDM) self-test.
If DTC B1342 is retrieved again, replace DDM.
See DRIVER DOOR MODULE (DDM) .
B1530 Memory Set Switch Circuit Short To Ground G
B1534 Memory 1 Switch Circuit Short To Ground G
B1538 Memory 2 Switch Circuit Short To Ground G
B2320 Driver's Mirror Horizontal Feedback Potentiometer Circuit Failure E
B2324 Driver's Mirror Vertical Feedback Potentiometer Circuit Failure E
B2336 Mirror Switch Assembly Circuit Failure E
FRONT ELECTRONICS MODULE (FEM) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Perform Test
B1342 FEM Defective Using NGS tester, clear and document all DTCs. Perform Front Electronic Module (FEM) self-test.
If DTC B1342 is retrieved again, replace FEM.
See FRONT ELECTRONIC MODULE (FEM) .
B2312 Passenger's Mirror Horizontal Feedback Potentiometer Circuit Failure E
B2316 Passenger's Mirror Vertical Feedback Potentiometer Circuit Failure E
REAR ELECTRONICS MODULE (REM) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Perform Test
B1342 REM Defective Using NGS tester, clear and document all DTCs. Perform Rear Electronic Module (REM) self-test.
If DTC B1342 is retrieved again, replace REM.
See REAR ELECTRONIC MODULE (REM)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.