Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Lincoln Town Car BaseFACTORY OEM SERVICE PROCEDURE
Test D: Remote Keyless Entry Out Of Synchronization
- Resynchronize Remote Transmitter - Press any button on inoperative remote transmitter 4 times consecutively. If remote transmitter does not operate properly, go to next step. If remote transmitter operates properly, system is operating properly at this time.
- Check For Second Remote Transmitter - Check to see if another operating remote transmitter is available with vehicle. If another operating remote transmitter is available with vehicle, go to next step. If another operating remote transmitter is not available with vehicle, go to step 4).
- Resynchronize Inoperative Remote Transmitter Using Second Remote Transmitter - Press any button on operating remote transmitter. Within 30 seconds of pressing any button on operating remote transmitter, press any button on inoperative remote transmitter. Check to see if inoperative remote transmitter now operates properly. If inoperative remote transmitter still does not operate properly, go to next step. If inoperative remote transmitter now operates properly, clear DTCs and retest system operation.
- Program Inoperative Remote Transmitter - Program inoperative remote transmitter. See REMOTE TRANSMITTER under PROGRAMMING. If inoperative remote transmitter still does not operate properly, perform TEST B: DOOR LOCKS ARE INOPERATIVE USING REMOTE TRANSMITTER . If inoperative remote transmitter now operates properly, clear DTCs. Inform customer that any remote transmitters not available at time of programming will need to be reprogrammed at the same time. Retest system operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
