1997 Lincoln Mark VIII LSCFACTORY OEM SERVICE PROCEDURE

Test N: No Module/Network Communication

WARNING: This page is about a different car, the 1998 Lincoln Mark VIII. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect NGS tester connector for loose, damaged or corroded terminals. Repair as necessary and retest system for normal operation. If connector is okay, go to next step.
  2. Turn ignition off. Inspect Data Link Connector (DLC) for physical damage, bent terminals or corrosion. Repair as necessary and retest system for normal operation. If connector is okay, go to next step.
  3. Turn ignition off. Remove and inspect fuse No. 38 (10-amp) from instrument panel fuse block. If fuse is blown, go to next step. If fuse is okay, reinstall fuse and go to step 5).
  4. Replace fuse and retest system for normal operation. Recheck fuse. If fuse is okay, go to next step. If fuse is blown, repair short to ground in circuit No. 1047 (Light Green/Red wire) between instrument panel fuse block and DLC. Retest system for normal operation.
  5. Measure voltage between ground and terminal No. 16 (Light Green/Red wire) at DLC. See Figure. If voltage is more than 10 volts, go to next step. If voltage is 10 volts or less, repair circuit No. 1047 (Light Green/Red wire) between instrument panel fuse block and DLC. Retest system for normal operation.
  6. Measure resistance between ground and terminals No. 4 (Black wire) and No. 5 (Black/Light Blue wire) at DLC. If both resistance readings are less than 5 ohms, repair or replace NGS tester. Retest system for normal operation. If any resistance reading is 5 ohms or more, repair open in Black wire or Black/Light Blue wire between ground and DLC. Retest system for normal operation.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.