Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Lincoln Mark VII BaseFACTORY OEM SERVICE PROCEDURE
Toe-In Adjustment
NOTE:
DO NOTΒ
grip threads while loosening jam nut or tear rubber boot on tie rod during adjustment.
- Start engine (power steering only). Move steering wheel back and forth several times until wheel is centered. Turn off engine. Lock steering wheel into position with steering wheel holder.
- Loosen jam nuts on each tie rod assembly. Adjust toe. If steering wheel spokes are in their normal position, lengthen or shorten both tie rods equally to obtain correct toe.
- When toe and steering wheel spoke position are both correct, lubricate jam nuts and tighten. The jam nuts and boots on each side of vehicle must be positioned as shown in Fig. Fig 1 .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
