Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Lexus RX 350 Base, FWDFACTORY OEM SERVICE PROCEDURE
Dynamic Torque Control AWD System
DYNAMIC TORQUE CONTROL AWD SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION - [09/2015 - 08/2019]
| DTC Code | Description |
|---|---|
| C120C/79 | Linear Solenoid Power Supply System Malfunction |
| C1241/94 | Low Power Supply Voltage |
| C1280/82 | Engine Circuit Malfunction |
| C1296/96 | ABS Malfunction |
| C1297/97 | Steering Angle Sensor |
| C1298/98 | Linear Solenoid Circuit |
| C1299/99 | Cancellation of 4WD Control |
| C1337/91 | Diameter of the Tire is not Uniform |
| U0073/86 | Control Module Communication Bus OFF |
| U0100/85 | Lost Communication with ECM / PCM "A" |
| U0126/84 | Lost Communication with Steering Angle Sensor Module |
| U0129/83 | Lost Communication with Brake System Control Module |
DYNAMIC TORQUE CONTROL AWD SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION - [08/2019 - ]
| DTC Code | Description |
|---|---|
| C120C | Linear Solenoid Power Supply System Malfunction |
| C1241 | Low or High Power Supply Voltage |
| C1280 | Engine Circuit Malfunction |
| C1296 | ABS Malfunction |
| C1297 | Steering Angle Sensor |
| C1298 | Linear Solenoid Circuit |
| C1299 | Cancellation of 4WD Control |
| C1337 | Diameter of the Tire is not Uniform |
| U0073 | Control Module Communication Bus Off |
| U0100 | Lost Communication with ECM / PCM "A" |
| U0126 | Lost Communication with Steering Angle Sensor Module |
| U0129 | Lost Communication with Brake System Control Module |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
