2021 Lexus LS 500 Base, AWDFACTORY OEM SERVICE PROCEDURE

On-Vehicle Inspection [12/2017 - ]: Procedure

  1. INSPECT NO. 1 TURBO PRESSURE SENSOR 
    1. Connect the Techstream to the DLC3.
    2. Turn the Techstream on.
    3. Warm up the engine.
    4. Turn the A/C switch off.
    5. Enter the following menus: Powertrain / Engine / Data List / Boost Pressure Sensor and Boost Pressure Sensor2

      Powertrain > Engine > Data List 

      Tester Display
      Boost Pressure Sensor
      Boost Pressure Sensor2
    6. Read the air pressure value from the Data List.

      HINT: 

      • Standard atmospheric pressure is approximately 101 kPa (abs) (15 psi (abs)).
      • For every 100 m (328 ft) increase in altitude, atmospheric pressure drops by approximately 1 kPa (0.15 psi). This varies by weather.
    7. Using a vacuum pump, set the No. 1 turbo pressure sensor.
    8. Using a vacuum pump, read the value when pressure is applied and when pressure is decreased.

      OK

      The pressure values when applying pressure or decreasing pressure using the vacuum pump and the Data List values are nearly the same.

      NOTE:
      • Do not apply a pressure of 50 kPa (0.5 kgf/cm2 , 7.3 psi) or more to the No. 1 turbo pressure sensor.
      • Do not apply a vacuum of 50 kPa (375 mmHg, 14.8 in.Hg) or more to the No. 1 turbo pressure sensor.

      HINT: 

      The pressure value displayed in the Data List is the pressure value indicated on the vacuum pump with the air pressure value added.

      EXAMPLE:

      Vacuum Pump Pressure Value Air Pressure Value Equation Data List Value
      When vacuum is applied at 30 kPa (225 mmHg, 8.86 in.Hg) 100 kPa (1.0 kgf/cm2 , 15 psi) -30 + 100 = 70 70 kPa (0.7 kgf/cm2 , 10.2 psi)
      When pressure is applied at 30 kPa (0.3 kgf/cm2 , 4 psi) 30 + 100 = 130 130 kPa (1.3 kgf/cm2 , 19 psi)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.