Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
How To Proceed With Troubleshooting [08/2015 - 08/2019]: Procedure
- VEHICLE BROUGHT TO WORKSHOP
Result
Proceed to NEXT Result:
NEXT
See step 2
- INSPECT BATTERY VOLTAGE
Standard voltage
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
Result
Proceed to NEXT Result:
NEXT
See step 3
- CHECK CAN COMMUNICATION SYSTEM*
- Using the Techstream, check if the CAN communication system is functioning normally.
Result
Result Proceed to CAN DTC is not output A CAN DTC is output B
Result:
B
GO TO CAN COMMUNICATION SYSTEM. Refer to DIAGNOSIS SYSTEM [08/2015 - 08/2019]
Result:
A
See step 4
- Using the Techstream, check if the CAN communication system is functioning normally.
- CHECK FOR DTC*
- Check for DTCs.
- Clear the DTCs.
- Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the pre-collision system DTCs by simulating the conditions indicated by the DTCs.
Result
Result Proceed to DTC is not output A DTC is output B
Result:
B
GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2015 - 08/2019]
Result:
A
See step 5
- PROBLEM SYMPTOMS TABLE
- Refer to Problem Symptoms Table.
Refer to PROBLEM SYMPTOMS TABLE [08/2015 - 08/2019]
Result
Result Proceed to Fault is not listed in problem symptoms table A Fault is listed in problem symptoms table B
Result:
B
See step 7
Result:
A
See step 6
- Refer to Problem Symptoms Table.
- OVERALL ANALYSIS AND TROUBLESHOOTING*
- Terminals of ECU
Refer to TERMINALS OF ECU [08/2015 - 08/2019]
- Data List / Active Test
Refer to DATA LIST / ACTIVE TEST [08/2015 - 08/2019]
Result
Proceed to NEXT
Result:
NEXT
See step 7
- Terminals of ECU
- ADJUST, REPAIR OR REPLACE NOTE:
- When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.
Refer to ADJUSTMENT [08/2015 - 08/2019]
- w/ Lane Departure Alert System:
When the lane recognition camera sensor assembly is replaced with a new one, adjustment of the camera sensor beam axis must be performed.
Refer to ADJUSTMENT [08/2015 - 08/2019]
Result
Proceed to NEXT Result:
NEXT
See step 8
- When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.
- CONFIRMATION TEST
Result
Proceed to NEXT Result:
NEXT
END
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
