Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Lexus GS 300 BaseFACTORY OEM SERVICE PROCEDURE
Night View System
NIGHT VIEW SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC Code | Description |
|---|---|
| B280A | ECU Malfunction |
| B2815 | Low Beam Headlights do not Illuminate |
| B281A | Camera not Adjusted |
| B281B | Near Infrared Camera Power Supply Malfunction |
| B281C | Near Infrared Camera Sync Signal is not received |
| B2816 | Near Infrared Radiation Floodlight RH |
| B2817 | Near Infrared Radiation Floodlight LH |
| B2821 | Body Multiplex Signal Abnormal Condition |
| B2824 | Driving Support ECU Received Invalid Flag |
| B2825 | Automatic Light Control Sensor Invalid Value |
| B2827 | Initial Setting is not Appropriate |
| U1104 | Lost Communication with Driving Support ECU |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
