Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Lexus RC FFACTORY OEM SERVICE PROCEDURE
On-Vehicle Inspection [09/2014 - ]: Procedure
- INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
Powertrain > Engine > Data List
Tester Display Accel Sensor Out No. 1 Accel Sensor Out No. 2 - Read the values displayed on the Techstream.
Standard Voltage
Tester Display Condition Specified Condition Accel Sensor Out No. 1 Accelerator pedal fully released 0.5 to 1.1 V Accelerator pedal fully depressed 2.6 to 4.5 V Accel Sensor Out No. 2 Accelerator pedal fully released 1.2 to 2.0 V Accelerator pedal fully depressed 3.4 to 4.75 V If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.