Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
How To Proceed With Troubleshooting [09/2015 - ]: Procedure
- VEHICLE BROUGHT TO WORKSHOP
Result
Proceed to NEXT Result: 1
NEXT
Refer to 2
- INSPECT AUXILIARY BATTERY VOLTAGE
Standard voltage
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding.
Result
Proceed to NEXT Result: 1
NEXT
Refer to 3
- CHECK FOR DTC*
- Check for DTCs and make a note of any codes that are output.
- Clear the DTC.
- Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the same DTC by simulating the symptoms indicated by the DTC.
Result
Result Proceed to No DTCs output A B2311 is output B B2312 is output B B2313 is output B CAN communication system DTC output reoccur C LIN communication system DTC output reoccur D
Result: 2
B
GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2015 - ]
Result: 3
C
GO TO CAN COMMUNICATION SYSTEM. Refer to PRECAUTION [09/2015 - ]
Result: 4
D
GO TO LIN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2015 - ]
Result: 1
A
Refer to 4
- PROBLEM SYMPTOMS TABLE
- Refer to the problem symptoms table.
Refer to PROBLEM SYMPTOMS TABLE [09/2015 - ]
Result
Result Proceed to Fault not listed in problem symptoms table A Fault listed in problem symptoms table B
Result: 2
B
Refer to 6
Result: 1
A
Refer to 5
- Refer to the problem symptoms table.
- OVERALL ANALYSIS AND TROUBLESHOOTING*
- Operation Check.
Refer to OPERATION CHECK [09/2015 - ]
- Terminals of ECU.
Refer to TERMINALS OF ECU [09/2015 - ]
- Data List / Active Test.
Refer to DATA LIST / ACTIVE TEST [09/2015 - ]
Result
Proceed to NEXT
Result: 1
NEXT
Refer to 6
- Operation Check.
- REPAIR OR REPLACE
Result
Result Proceed to Door window regulator and power window regulator motor assembly is replaced or removed/installed. A Door window regulator and power window regulator motor assembly is not replaced or removed/installed. B Result: 2
B
Refer to 8
Result: 1
A
Refer to 7
- PERFORM INITIALIZATION
- Initialization the power window motor.
Refer to INITIALIZATION [09/2015 - ]
Result
Proceed to NEXT
Result: 1
NEXT
Refer to 8
- Initialization the power window motor.
- CONFIRMATION TEST
Result
Proceed to NEXT Result: 1
NEXT
END
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
