2016 Lexus IS 300 BaseFACTORY OEM SERVICE PROCEDURE

Removal [04/2013 - 10/2017]: Procedure

  1. REMOVE FUEL INJECTOR SEAL 

    Refer to REMOVAL [04/2013 - 10/2017]

  2. REMOVE KNOCK CONTROL SENSOR 
    1. Disconnect the 2 knock control sensor connectors.
      GTY471224Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Engine Front
    2. Remove the 2 bolts and 2 knock control sensors from the cylinder block sub-assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.