2016 Lexus IS 300 BaseFACTORY OEM SERVICE PROCEDURE

Components [04/2013 - 10/2017]

Fig 1: Heated Oxygen Sensor Replacement Components With Torque Specifications (1 Of 2)
GTY463183Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
*A For 2WD - -
*1 HEATED OXYGEN SENSOR (for Bank 1) *2 HEATED OXYGEN SENSOR (for Bank 2)
N*m (kgf*cm, ft.*lbf): Specified torque * For use with SST
Fig 2: Heated Oxygen Sensor Replacement Components With Torque Specifications (2 Of 2)
GTY458163Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
*A For AWD *B w/ Front Floor Cover LH
*1 HEATED OXYGEN SENSOR (for Bank 1) *2 HEATED OXYGEN SENSOR (for Bank 2)
*3 FRONT FLOOR COVER LH - -
N*m (kgf*cm, ft.*lbf): Specified torque * For use with SST
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.