Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P060B: Internal Control Module A/D Processing Performance: Procedure
- CHECK DTC
- Clear DTCs. Refer to DTC CHECK / CLEAR [09/2012 - ] .
- Disconnect the cable from the negative (-) battery terminal and wait for 1 minute. Refer to PRECAUTION [09/2012 - ] .
- Connect the cable to the negative (-) battery terminal. Refer to PRECAUTION [09/2012 - ] .
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG) and and turn the Techstream on.
- Wait 16 seconds or more.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Check for DTCs.RESULT
Display (DTC Output) Proceed to No output A P060B B P060B and P0327, P0328, P032C, P032D, P0332, P0333, P033C or P033D C
B → See step 3
C → See step 4
A → See step 2
- CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [09/2012 - ]
- REPLACE ECM. Refer to REMOVAL [09/2012 - ]
- GO TO DTC (P0327, P0328, P032C, P032D, P0332, P0333, P033C and P033D). Refer to DTC P0327: Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor); DTC P0328: Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor); DTC P032C: Knock Sensor 3 Circuit Low; DTC P032D: Knock Sensor 3 Circuit High; DTC P0332: Knock Sensor 2 Circuit Low Input (Bank 2); DTC P0333: Knock Sensor 2 Circuit High Input (Bank 2); DTC P033C: Knock Sensor 4 Circuit Low Input; DTC P033D: Knock Sensor 4 Circuit High Input
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.