2013 Lexus LS 460 Base, AWDFACTORY OEM SERVICE PROCEDURE

DTC P060B: Internal Control Module A/D Processing Performance: Procedure

  1. CHECK DTC 
    1. Clear DTCs. Refer to DTC CHECK / CLEAR [09/2012 - ] .
    2. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute. Refer to PRECAUTION [09/2012 - ] .
    3. Connect the cable to the negative (-) battery terminal. Refer to PRECAUTION [09/2012 - ] .
    4. Connect the Techstream to the DLC3.
    5. Turn the engine switch on (IG) and and turn the Techstream on.
    6. Wait 16 seconds or more.
    7. Enter the following menus: Powertrain / Engine / Trouble Codes.
    8. Check for DTCs.
      RESULT

      Display (DTC Output) Proceed to
      No output A
      P060B B
      P060B and P0327, P0328, P032C, P032D, P0332, P0333, P033C or P033D C

    B → See step   3 

    C → See step   4 

    A → See step   2 

  2. CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [09/2012 - ] 
  3. REPLACE ECM. Refer to  REMOVAL [09/2012 - ] 
  4. GO TO DTC (P0327, P0328, P032C, P032D, P0332, P0333, P033C and P033D). Refer to  DTC P0327: Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor); DTC P0328: Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor); DTC P032C: Knock Sensor 3 Circuit Low; DTC P032D: Knock Sensor 3 Circuit High; DTC P0332: Knock Sensor 2 Circuit Low Input (Bank 2); DTC P0333: Knock Sensor 2 Circuit High Input (Bank 2); DTC P033C: Knock Sensor 4 Circuit Low Input; DTC P033D: Knock Sensor 4 Circuit High Input 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.