Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Lexus IS 350C BaseFACTORY OEM SERVICE PROCEDURE
Engine Control System (Diagnostic Codes (P060D-U010) & Circuit Tests)
- SFI System
- DTC P060D: Internal Control Module Accelerator Pedal Position Performance
- DTC P060E: Internal Control Module Throttle Position Performance
- DTC P0617: Starter Relay Circuit High
- DTC P062F: Internal Control Module EEPROM Error
- DTC P0630: VIN not Programmed or Mismatch - ECM / PCM
- DTC P0657: Actuator Supply Voltage Circuit / Open
- DTC P0724: Brake Switch "B" Circuit High
- DTC P1235: High Pressure Fuel Pump Circuit
- DTC P1276: Port Injector Circuit No. 1; DTC P1277: Port Injector Circuit No. 2; DTC P1278: Port Injector Circuit No. 3; DTC P1279: Port Injector Circuit No. 4; DTC P127A: Port Injector Circuit No. 5; DTC P127B: Port Injector Circuit No. 6
- DTC P1607: Cruise Control Input Processor
- DTC P2102: Throttle Actuator Control Motor Circuit Low; DTC P2103: Throttle Actuator Control Motor Circuit High
- DTC P2111: Throttle Actuator Control System - Stuck Open; DTC P2112: Throttle Actuator Control System - Stuck Closed
- DTC P2118: Throttle Actuator Control Motor Current Range / Performance
- DTC P2119: Throttle Actuator Control Throttle Body Range / Performance
- DTC P2120: Throttle / Pedal Position Sensor / Switch "D" Circuit; DTC P2122: Throttle / Pedal Position Sensor / Switch "D" Circuit Low Input; DTC P2123: Throttle / Pedal Position Sensor / Switch "D" Circuit High Input; DTC P2125: Throttle / Pedal Position Sensor / Switch "E" Circuit; DTC P2127: Throttle / Pedal Position Sensor / Switch "E" Circuit Low Input; DTC P2128: Throttle / Pedal Position Sensor / Switch "E" Circuit High Input; DTC P2138: Throttle / Pedal Position Sensor / Switch "D" / "E" Voltage Correlation
- DTC P2121: Throttle / Pedal Position Sensor / Switch "D" Circuit Range / Performance
- DTC P2195: Oxygen (A/F) Sensor Signal Stuck Lean (Bank 1 Sensor 1); DTC P2196: Oxygen (A/F) Sensor Signal Stuck Rich (Bank 1 Sensor 1); DTC P2197: Oxygen (A/F) Sensor Signal Stuck Lean (Bank 2 Sensor 1); DTC P2198: Oxygen (A/F) Sensor Signal Stuck Rich (Bank 2 Sensor 1)
- DTC P2237: Oxygen (A/F) Sensor Pumping Current Circuit / Open (Bank 1 Sensor 1); DTC P2238: Oxygen (A/F) Sensor Pumping Current Circuit Low (Bank 1 Sensor 1); DTC P2239: Oxygen (A/F) Sensor Pumping Current Circuit High (Bank 1 Sensor 1); DTC P2240: Oxygen (A/F) Sensor Pumping Current Circuit / Open (Bank 2 Sensor 1); DTC P2241: Oxygen (A/F) Sensor Pumping Current Circuit Low (Bank 2 Sensor 1); DTC P2242: Oxygen (A/F) Sensor Pumping Current Circuit High (Bank 2 Sensor 1); DTC P2252: Oxygen (A/F) Sensor Reference Ground Circuit Low (Bank 1 Sensor 1); DTC P2253: Oxygen (A/F) Sensor Reference Ground Circuit High (Bank 1 Sensor 1); DTC P2255: Oxygen (A/F) Sensor Reference Ground Circuit Low (Bank 2 Sensor 1); DTC P2256: Oxygen (A/F) Sensor Reference Ground Circuit High (Bank 2 Sensor 1)
- DTC P2420: Evaporative Emission System Switching Valve Control Circuit High
- DTC P2610: ECM / PCM Internal Engine Off Timer Performance
- DTC U0101: Lost Communication with TCM
- Circuit Test
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.
