Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Monitor Description
The ECM monitors the signals of the throttle position sensor No. 1 and stop light switch assembly. When the ECM monitors the input signals of the throttle position sensor No. 1 and the STP signals of the stop light switch assembly, if the input signals and control signals deviate, the DTC is stored.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P060E | Either of the following conditions is met (1 trip detection logic):
|
ECM |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.