Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Lexus GS 350 Base, RWDFACTORY OEM SERVICE PROCEDURE
Component Locations
Select a section or procedure below to view factory instructions:
Air Conditioning SystemAudio / Video SystemAutomatic Transmission (A760E)Automatic Transmission (A760H)Blind Spot MonitorCan Communication SystemCharging SystemClimate Control Seat SystemClockCruise Control SystemDynamic Radar Cruise Control SystemDynamic Rear Steering SystemElectric Parking Brake SystemEmission Control SystemEngine Control SystemEngine Immobiliser SystemENIGINE Cooling FanFront Power Seat Control SystemFuel Lid OpenerFuel SystemGarage Door OpenerHeated Steering WheelHornIgnition SystemIntuitive Parking Assist SystemLane Keeping Assist SystemLEXUS ENFORM SystemLighting System (Exterior)Lighting System (Interior)Lin Communication SystemLuggage Compartment Door Closer SystemLuggage Compartment Door Opener SystemMeter / Gauge / DisplayNavigation SystemNight View SystemOccupant Classification SystemParking Assist Monitor SystemPower Door Lock Control System (Courtesy Light, Power Door Lock Control)Power Door Lock Control System (Power Door Lock Fuse, Power Door Control Switch)Power Mirror ControlPower Steering SystemPower Tilt & Telescopic Steering ColumnPower Trunk LidPower Window Control SystemPre-Collision SystemRear Sunshade SystemRear View Monitor SystemSafety Connect SystemSeat Belt Tension ReducerSeat Belt Warning SystemSeat Heater SystemSliding Roof SystemSmart Access System (Keyless Entry)Smart Access System (Keyless Start)Starting SystemSteering Lock SystemSupplemental Restraint SystemSuspension Control SystemTheft Deterrent / Keyless Entry SystemTire Pressure Warning SystemTransfer CaseVariable Gear Ratio Steering SystemVehicle Stability Control SystemWindow Defogger SystemWindow Deicer SystemWiper System / Washer System
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.